感應門在自動感應狀態下使用時不可以擺放一些活動(或者風吹動會活動)的東西在門的感應頭檢測的范圍內，這會容易造成感應門的誤運動動作發生，那么正常狀態的濟南感應門應該是怎么樣的？下面小編為您講講。

When the induction door is used in the automatic induction state, it is not allowed to place some moving (or moving when the wind blows) things within the detection range of the door's induction head, which will easily cause the false movement of the induction door. What should the Jinan induction door be like in the normal state? The following is a brief introduction.

1、人員以正常速度從門外或門內走向感應門，感應門應該自動打開，感應門的動作應該平滑而且沒有出現碰撞的情況;感應門打開后，人員以每秒約150mm-200mm的速度慢速通過感應門時，感應門應該保持打開狀態。

1. When a person walks to the sensing door from the outside or inside of the door at normal speed, the sensing door should open automatically, and the action of the sensing door should be smooth without collision; After the sensing door is opened, the sensing door should remain open when the person passes through the sensing door slowly at a speed of about 150 mm-200 mm per second.

2、當人員離開感應門感應器感應區后，在延時1-10秒后(時間長短可以由感應門開關參數來設置)，感應門將自動關閉，感應門的動作應該平滑而且沒有出現碰撞的情況。

2. When the personnel leave the sensing area of the inductive door sensor, the inductive door will automatically close after a delay of 1-10 seconds (the length of time can be set by the switch parameters of the inductive door), and the action of the inductive door should be smooth without collision.

3、觀察人員正常通過感應門的行走路線，需要把日常行走路線調整為人員正對走向感應門，而不是以一定的角度走向感應門。

3. The observer's normal walking route through the sensing door requires that the daily walking route be adjusted so that the person is facing the sensing door, rather than walking to the sensing door at a certain angle.

4、走向感應門時，感應門感應器的感應寬度范圍應該大于門完全打開的寬度。

4. When walking to the sensing door, the sensing width range of the sensing door sensor should be greater than the width of the fully opened door.

5、如果感應門安裝了輔助光線傳感器(紅外對射保護裝置)，當門打開時，人站著不動，用手遮擋輔助光線傳感器，門應該保持打開狀態。當手離開后幾秒內，門應該重新關閉。

5. If the induction door is equipped with an auxiliary light sensor (infrared radiation protection device), when the door is opened, people stand still and block the auxiliary light sensor with their hands, and the door should remain open. The door should be closed again within a few seconds of the hand leaving.

保障感應門、可靠地運行，用戶或感應門管理人員在日常需要對感應門進行必要的運行檢查和保養，好找專門的人員進行，這樣不會出現問題，更多相關內容就來我們網站http://www.hrshirt.cn咨詢吧！

Ensure the safe and reliable operation of the sensing door. Users or sensing door managers need to carry out necessary operation inspection and maintenance of the sensing door on a daily basis, so that they can find special personnel to carry out, so that no problems will occur. More relevant content will come to our website http://www.hrshirt.cn Consult!